17
Subject to change without notice | 83050400fUK – Translation into English of the original German operating manual | ait-deutschland GmbH
1 Masonry of the house exterior
2 Insert the wall duct in the
masonry (1 cm above the
finished outer facade)
or retrofit (using foam in the masonry):
1 Finished outer facade
NOTICE.
Wall ducts fix wall openings, help avoid cold air
transmission in the masonry as well as assist in
the assembly of weather / rain guards and wire
mesh grilles
AIR DUCTS ASSEMBLY
Remove the parts necessary for the assembly of the
air duct(s) from their respective boxes…
The interlocking of the air ducts is carried out
as described in the section – entitled “Wall
duct(s) assembly”.
SECURING THE AIR DUCT INTO THE WALL DUCT
Pull the roll seal included with delivery over the end
of the air duct…
Push this end of the air duct into the wall duct.
1 wall duct
2 air duct
3 roll seal
4 betonite waterstop tape (attach
only after assembling the
unit's connection fastener)
NOTICE.
After the other end of the air duct has been se-
cured to the heat pump, close the opening be-
tween the wall duct and the air duct using the
betonite waterstop tape included with delivery.
SECURING THE AIR DUCT ON THE HEAT PUMP
Clip on the assembly rail and secure it using special
screws to the spot on the air duct designated as the
air intake side…
Stick the adapter base included with delivery on the
edge of the air duct…
Position the air duct on the respective opening of
the air intake side…
