13
Subject to change without notice | 83050400fUK – Translation into English of the original German operating manual | ait-deutschland GmbH
Dispose of angle bracket, transport and packaging
material properly and in accordance with ecological
principles…
Set unit on a stable, solid and level, preferably sound-
insulated surface. Make sure that the foundation is
designed for the weight of the heat pump…
Overview “Technical data/scope of delivery”,
“General unit data” section.
Mount feet…
ATTENTION
Moving the unit without the feet mounted can
damage the floor.
•
Tip the unit slowly and carefully to one side…
Secure unit in raised position so that it cannot
accidentally tip back into the original position.
CAUTION!
Hands and fingers could be crushed during
the following tasks!
•
Mount one foot each on the front and back of the
unit…
1 Foot
2 Lock nut
3 Adjusting screw
•
Slowly and carefully tip the unit back into the
original position…
•
Repeat procedure on the other side of the unit.
Place unit at final installation location.
Compensate for minor unevenness using the four
adjusting screws and align the unit horizontally.
Then tighten the lock nuts.
Installation of the
ventilation duct
CONVERTING FROM AIR BLOWER ON THE RIGHT
TO AIR BLOWER ON THE LEFT
NOTICE.
Note the air blow-out direction of the unit.
– By default, the units ship with the air blower
on the
right hand
side.
Remove top front panel and set it aside on the floor.
While doing so, rotate the front panel by 180° to
protect the capillary…
“Manometer”.
ATTENTION
Pay attention to the manometer capillary.
Remove the side panel on the top left and right by
unscrewing the 2 screws on each side…
