Alpha-InnoTec LW 161H/V, Operating Manual

Page: 11 / 48

11
Subject to change without notice | 83061600bUK | ait-deutschland GmbH
4. Pass the tube handles through the holes in the
frame:
1 Holes in the frame, front and rear
Make sure that the tube handles do not damage
cable harnesses and components in the unit.
Feed the tube handles carefully past cable
harnesses and components in the unit.
5. Lift the unit with the inserted tube handles, with at
least four people (one for each tube handle) and
carry to the place of installation.
CAUTION
Carry the unit horizontally and secure it
against slipping.
6. Put down the unit at the place of installation. Make
sure that the unit's baseframe is in full contact
with the surface of the floor.
7. Remove the tube handles.
8. If the electrical connection work is not carried out
immediately, re-attach the lower facade panel on
the operating side.
Push-in fan
The fan can be pushed approx. 10 cm into the housing
to enable the unit to be transported in narrow basement
rooms and through narrow doors or corridors:
1 Fan in delivery condition
2 Fan pushed into the unit
IMPORTANT
Only push the fan into the housing for
transport purposes and pull it back out of the
housing immediately after transport.
1. Remove the lower facing panel on the fan side
and remove it from the unit. To do this, undo the
quick-release screws. Turn through 90° to the left.
1 Quick-release screws
2 Lower facing panel