ADM-XRC-7Z1 User Manual
V2.6 - 14th February 2022
2 PCB Information
2.1 Physical Specifications
Form Factor
Single Width XMC
Length (air-cooled)
149.0 mm
Length (conduction-cooled)
143.75 mm
Width
74.0 mm
Height
10.0 mm
Weight (air-cooled)
TBD
Weight (conduction-cooled)
TBD
Table 3 : Physical Specifications
2.2 Motherboard / Carrier Requirements
The 7Z1 is a single width XMC.3 mezzanine with P5, P6 and P4 connectors.
The 7Z1 is compatible with either 5V or 12V on the "VPWR" power rail.
The Primary XMC connector, P5, is compatible with the XMC.3 (VITA 42.3) specification for PCI Express
applications.
The Secondary XMC connector, P6 also has a pinout compatible with XMC.3. Since carriers may have differing
pinouts on this connector, it is important to check compatibility prior to installation. If in doubt, please contact
Alpha Data for assistance.
IMPORTANT
Connector P6 on the card is not compatible with the VITA 42.10 (XMC GPIO) Standard. In particular, USB
VCC must not be applied on this connector.
The PMC connector, P4, has the main interfaces to the ARM Processing System (PS): Ethernet, USB and serial
ports. The pinout of this connector is compatible with other commercially available PrPMCs but is not defined by
a VITA standard. It is important to check carrier card compatibility prior to installation. If in doubt, please contact
Alpha Data for assistance.
IMPORTANT
Connector P4 has +5V (power) -/+6V (serial port) levels. It must not be connected to the Alpha Data
ADM-EMC-II or ADM-XMC-II carrier cards. Please contact Alpha Data for carrier card compatibility.
2.3 Power Requirements
The power dissipation of the board is highly dependent on the Target FPGA application. A power estimator
spreadsheet is available on request from Alpha Data. This should be used in conjunction with Xilinx's power
estimation tools to determine the exact current requirements for each power rail.
Page 3
PCB Information
ad-ug-1253_v2_6.pdf
