5
9. To add alarm devices such as the ‘Motion Detector MD 101’ and ‘DOOR/WINDOW SENSOR
DWS 102’, activate the power by removing the protective plastic insert from in between the battery and the
battery holder contacts on the circuit board, while depressing the tamper. At the conclusion of registration,
the alarm device indicator flashes red 3 times and the Socket emits a single beep.
6 alarm devices of these 2 types can be added into the Socket memory.
Attention! When registering ‘Door/Window Sensor DWS 102’ alarm devices, place the magnet
that came with the unit, near the Symbol ‘
>
’ located on the body of the device in order to activate the built
in magnetic switch.
10. The primary registered telephone number will receive an SMS notification showing the
registered devices; 1st SMS with settings and a 2nd SMS showing registered keychain controllers, sirens
and alarm devices.
After sending the SMS's, the Socket enters the <<DISARMED>> mode.
11. Close the cover on the Socket, siren and alarm device(s) and tighten down the screw(s).
SAFETY PRECAUTIONS
Do not connect electrical devices whose power requirements exceed allowances permitted for
electrical wiring, receptacles and the GSM Socket.
Do not install inside premises containing a high concentration of water vapors or in areas with
inadequate ventilation (conditions for high electrical conductivity might be created). The device is not
waterproof. Do not expose the device to harsh environmental conditions (for example; rain, leaking
liquids, etc.).
It is prohibited to install the device in premises containing dangerous explosive substances.
