3
TURNING POWER ON AND SET UP
1. Remove the battery compartment cover from the Socket. If the
battery cover is screwed down; remove the screw.
2. Insert the SIM card into the SIM card holder located on the Socket
circuit board. The angled portion of the SIM card should be aligned with the
lower right hand corner of the holder.
3. If you purchased a siren and alarm devices; remove the packaging.
If present, remove the screw from the lower portion of the casing. On the siren,
insert a flat tipped screwdriver alternately into slots located on the right and left
sides of the screw and pry open. Remove the covers from the siren and alarm
devices.
4. Insert a battery into the Socket observing proper polarity. A single
beep will sound and the light diodes, <<ZONE>>, <<LINK>> and
<<POWER>> will glow orange to indicate power is on.
5. Wait for 3 beeps to sound; light diodes <<ZONE>> will steadily
glow orange, <<LINK>> will indicate GSM signal strength (green for good or
red for weak) and <<POWER>> will not be lit. This sequence indicates that the
Socket is in programming mode.
