OWNER'S MANUAL OF SEEDING-DRILL AS1
Old Cod.Q00A00136
New Cod. MANT2010/00634 R.2
MAINTENANCE
- 25
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
6.3.
REMOVING THE SEEDS FROM THE HOPPER
To discharge the seed hopper proceed as follows:
place a container under the grey corrugated pipe and open the unloading shutter
A. Remove all the product then, when finished, close the shutter again and block
it with the relative pin.
6.4.
END OF SEASON OPERATIONS
At the end of the season or if the equipment is not to be used for a long period of time, it is advisable to:
•
Carefully remove all the seeds from the hopper and the distribution organs
•
Wash the equipment with plenty of water, in particular the tank, then dry it. During washing keep door B (figure above) open
and remove the connecting joint to the Venturi (ref. B point 5.3).
•
Accurately check and if necessary replace any damaged or worn parts.
•
Tighten all screws.
•
Place a layer of lubricant on all unpainted parts.
•
Protect the equipment with a sheet of cloth.
•
Place the equipment on a dry, flat surface and keep it out of the reach of unauthorised people.
It goes to your advantage if you find the machine ready for use the next time.
