Auto-Pure series Operation Manual
Chapter 4 Operation
─
22
─
For Auto-Pure 20A, only well location 1, 2 & 9 have heating function.
For Auto-Pure 20B, only well location 1 & 7 have heating function.
For Auto-Pure 24BT, only well location 1 & 8 have heating function.
For Auto-Pure 24D, only well location 1 & 6 have heating function.
For Auto-Pure 32A, only well location 1 & 6 (Corresponding to the well location of 1,6,7
&12 for 96 well plate ) have heating function.
For Auto-Pure 48A, only well location 1,4 (Corresponding to the well location of 1,4,5,8,9
&12 for 96 well plate ) have heating function.
“Temperature” number box is available to input the temperature value that would like to set.
If input the number of “37” or below, then the device won’t heating when running to this
step.
When selecting other wells location than the above, the corresponding step line
"temperature" number box is not available .
Click “
” to enter the extended parameter setting interface, it isn’t necessary to set in normally
use, or you can reset if have special requirement. Click “
” back to the parameter setting
interface.
Click “Delete” and then click “OK” to delete the last step; or click “Cancel” not to delete the last step.
Click “Option” to set “Heating block”, “Temperature heating”, “Temperature cooling”, “Magnetic
function” and “Dry function ”, users may do the open setting for the protocol.
Click “Save” and then click “OK” to save the editing program; or click “Cancel” not to save the editing
program.
Click “Back”, if the new program has saved, then it will be back to “Management prog.” interface. If not,
Click “Yes” to save and back to “Management prog.” interface.
