ALLO PRI Gateway
User Manual V2.0
10
2. Getting started with PRI Gateway
2.1. Hardware Installation
Step 1: Plug one end of the RJ45 Ethernet cable into your Router & other end into the WAN port
of the PRI Gateway.
Note:
Use Straight-through Ethernet cable to connect between the unit & Router/Switch
Step 2: Plug one end of the RJ45 cable into the PRI 1 port of the PRI Gateway & other end to
the E1/T1 service provider socket.
Step 3: Insert the Power Adaptor output connector into the “Power” port of the PRI Gateway &
Plug in the Power Adapter to any available AC power outlet.
Step 4: The PRI Gateway will power up, and automatically connect itself to your network via
DHCP (which you can later configure in the SETTINGS > Network Settings section)
Note:
Wait until the unit is completely booted up and make sure that LED2 is green