ALLO PRI Gateway
User Manual V2.0
19
3.8 Network Settings:
The Networking Setting sub menu allows users to configure the LAN-side IP address and DHCP
Server settings, as well as the WAN-side settings like IP address of the WAN port.
By clicking on the
SETUP > Network Settings link
on the top navigation of the PRI Gateway
menu, we reach this section:
WAN Configuration
: Are the Internet settings of your PRI Gateway.
1.
DHCP
: when enabled and a DHCP server is available, the PRI Gateway will auto
configure itself. If DHCP is not available, select “
Static
”, and fill in the Network Configuration
2.
IP Address: the IP address corresponding to your WAN configuration*
3.
Net mask: the Net mask corresponding to your WAN configuration*
4.
Gateway: the IP address corresponding to your Gateway*
5.
DNS 1: the IP address corresponding to a DNS server*
6.
DNS 2: the IP address corresponding to a DNS server*
Important Note:
DHCP mode isn't recommended WAN side. Or trouble may arise when SIP trunk( From
Gateway) need to change registration server address caused by revised IP.
LAN Configuration:
Use this setting in the event that you want to use the PRI Gateway as your network router.
1.
IP Address
: It is a Base IP Address of a LAN Port, which functions as a gateway for its
LAN. Default value is 192.168.113.1 ( You can log in Web GUI through:192.168.113.2)
Important Note:
WAN port IP and LAN port IP Address shouldn't be in the same network segment.