ITA
ENG FRA ESP DEU POR
4 / 12
6-1622595 rev.06 13/01/2017
Compatible from
firmware version
CSMAM02
12
13
14
15
16
COURTESY LIGHT
Connect the courtesy light to the clamps 33 and
34, 230Vac 100W MAX.
It is possible to light up the action area of the
automatism during each motion.
The functioning of the auxiliary light is controlled by
the MENU A.
POWER SUPPLY
Connect the power supply cable to the clamps
26 and 27, connect the ground to one of the
clamps PE 28, 29 or 30.
Do not connect the card directly to the electric
network. Put a device which can ensure the
disconnection of each pole from the power supply of
the control unit
Use a cable with correct section according to the
current absorbed by the motor.
MOTOR OUTPUT
Connect the
common
of the motor to the clamp
23 of the control unit.
Connect the
open
of the motor to the clamp 22
of the control unit.
Connect
close
of the motor to the clamp 21 of
the control unit.
Before activating the automation make sure that all
the safey devices are correctly cabled and
functioning, refer to the preliminary checkings
section of chap.4
Cable the motor WITHOUT using the capacitor.
ACCESSORIES OUTPUTS
Accessories output 24Vdc 3W.
PHOTOCELLS POWER SUPPLY
Connect the
clamp 16
of the control unit to the
clamp +
of the power supply of the photocells
receiver.
Connect the
clamp 17
of the control unit to the
power supply
clamp -
of the photocells receiver
and of the transmitter.
Connect the
clamp 18
of the control unit to the
power supply
clamp
of the trasnmitter of the
photocells.
The photocells test test is activated by the MENU A.
ATTENTION:
the control unit gives a voltage of 24
Vdc and can supply a maximum power of 3W.
For the safety edges test connect the test device of
the safety edge on the power supply pins of the TX
(test activated wiht low logic signal 0Vdc).
Please refer to the manual of the safety edge.
FLASHING LIGHT
Connect the flashing light to the clamps 31 and
32.
Use a flashing light without self flashing card
230Vac 60W MAX
!! Risk of electric shock !!
For the connection of the motor we recom-
mend to use a screened cables 3 poles +
earth 1.5 mm
2
(type FD781CY)
