Allied 6025, Operator And Parts Manual

Page: 10 / 40

10
Assembly - Hydraulic Snowblower
Assembly Instructions
1. Unpack all components and remove from shipping material. Verify quantities provided with
parts listing.
NOTE: Depending on your shipping/assembly configuration, steps 2-3 may already be
completed.
2. Begin with spout to snowblower assembly:
- Place UHMV spout ring (815503) on top of spout base plate of snowblower fan
housing.
- Assemble spout retainer components (815506, 815507, 812364, 84048, 811791, 812363,
81570, 815508, 811795) to left hand set of holes according to the assembly views and
tighten all three bolts.
NOTE:
Ensure bolts are placed facing upwards so that nuts and washers are on top or
damage to the snowblower will result.
NOTE:
Avoid over tightening spout hardware. UHMW spout ring will deform/compress
from over torqued hardware (see Bolt Torque page) and cause binding in spout rotation.
- Slip spout base into assembled spout retainer and align so that right hand set can be
assembled using similar technique. Ensure spout rotates freely once hardware is tightened.
- Remove spout chain shield (815499) and install rotator chain (815496). Rotator motor
mounting holes are slotted to allow for installation and tightening of chain once connected.
Adjust position of sprocket (815497) on motor shaft so that sprocket is in line with chain tab
of spout. Adjust chain tightness and reattach chain shield.
3. Final hydraulic assembly
- Attach deflector cylinder (24930M) to spout in direction shown in photo 10 and install
adaptors into ports of cylinder as well as deflector ports of hydraulic manifold. Attach
deflector hoses as shown in photo 10, ensuring bottom port of cylinder attached to bottom
port of manifold. Install hose retaining hardware and tighten hoses and hardware once
suitable routing is established. Spout may need to be rotated part way to the left during
hose routing and tightening so that hoses do not become excessively twisted during CCW
spout travel.
- Install and tighten remaining two adaptors onto manifold.
- Install and tighten male and female quick couplers to the straight ends of supply hoses and
connect elbow ends to adaptors just installed. The top port is system input and male-tipped
hose should be connected to this port for most applications. Orientate elbow ends to the
right, ensuring hose routings are free from points where damage may occur and tighten.
NOTE: Hoses will be looped rearwards at a later time as shown in photo 2.