Chassis Installation
14
4. Remove the four screws and rubber feet from the bottom of all modules as
shown in Part A of Figure 11.
Figure 11: Removing the Rubber Feet
5. Re-install the same four screws you removed in Step 4 without the rubber
feet, as shown in Part B of Figure 11.
Note
After removing the rubber feet, you must replace the screws. Otherwise,
the unit will expand and not fit in the chassis. Save the rubber feet so they
may be used again in a standalone configuration at a later date.
6. Remove the dust covers from the backs of all newly-shipped ATI modules,
Figure 12: Removing the Dust Cover
A
B
INTERREPEA
TER BUS
FIRMW
ARE CASSET
TE
STA
TUS
POWER
MASTER
FAUL
T
INTERREPEA
TER BUS
FIRMW
ARE CASSET
TE
STA
TUS
POWER
MASTER
FAUL
T
IEEE 802.3
/ ETHERNET 1
0 BASE
2
8 PORT HUB
/ REPEA
TER
with Network Management
Dust cover
Hub with dust cover installed
Interrepeater bus
port connector
