Using the Web Configuration Interface
System
47
System
From the start page, click
System
. These pages allow you to perform administrative tasks.
Web
From the System page, click
Web
. This page allows you to control the device web server.
When you are finished, click
Change
.
Setting
Description
Status
Specify whether NAT should be enabled or disabled. If NAT is disabled, only one
computer can use the cellular link.
Maximum connections
Specify the total number of connections allowed from inside computers through
the cellular link. This is not the number of computers allowed to access the
Internet; a computer generates several connections. Up to 1024 connections are
allowed.
Translation timeout
Specify the length of time communication can be idle before a NAT connection is
closed, allowing internal resources to be reclaimed. This timeout value should be
increased if traffic is extremely intermittent.
Setting
Description
Enable
Click to specify whether the web server is enabled or disabled. If on, you can
configure the device through a web browser. If off, you can only configure the
device through Serial CLI, Telnet CLI, or SNMP.
