Installation
Before You Start
Supplies
For most installations, the basic supplies you will need are:
D818I_SVG
5
4
3
2
1
1.
Wrench
2.
Screwdriver
3.
Level
4.
Duct Tape
5.
Teflon Tape (Gas Models)
Figure 1
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
W299
Order of Installation Steps
1.
Position and level the dryer.
2.
Connect dryer to exhaust system.
3.
For gas models only, connect the gas supply pipe. Check for
gas leaks.
4.
For electric models only, connect the electrical cord.
5.
Reverse the door, if desired.
6.
Wipe out the inside of the dryer.
7.
Plug in the dryer.
8.
Recheck steps.
9.
Check heat source.
Position and Level the Dryer
1.
Install dryer before washer. This allows room for attaching
exhaust duct.
2.
Select a location with a solid floor. Dryers installed in resi-
dential garages must be elevated 18 inches [457 mm] above
the floor.
No other fuel burning appliance should be installed in the same
closet with the dryer.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Leveling legs can be adjusted from inside the dryer with 1/4 in.
driver. All four legs must rest firmly on the floor so the weight of
the dryer is evenly distributed.
The dryer needs sufficient clearance and an adequate air supply
for proper operation and ventilation, and for easier installation
and servicing. (Minimum clearances are shown in
Figure 3
).
3.
Place the dryer in position, and adjust the legs until the dryer
is level from side to side and front to back. The dryer must
not rock.
D669I_SVG
3
2
1
1.
Dryer Base
2.
Level
3.
Leveling Leg
Figure 2
Installation
Part No. 510963R7
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
7
Summary of Contents for Dryers
Page 2: ......
