800793
51
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
31. LOADING DOOR
a. Unlatch and open loading door.
b. Remove door bezel by prying inside lip up and
forward with fingers. Refer to Figure 18.
c. While supporting loading door, remove screws,
lockwashers and nuts holding loading door to
hinge assembly and remove door. Refer to
Figure 18.
32. DOOR SEAL AND HOSE ASSEMBLY
a. Model LTS85A*H Only:
NOTE: Front edge of cabinet top is held in place by
two spring clips located on top flange of front panel.
Refer to Figure 10.
(1) Insert putty knife between cabinet top and
top edge of front panel (approximately
three inches in front side). Refer to
Figure 10.
(2) Push in on putty knife and at the same time
lift top edge of cabinet top. Repeat for
opposite side.
(3) If area or space permits, lift cabinet top to a
vertical position (top will rest on hinges).
NOTE: To avoid damage to hinges, be sure to
support top with a chain (not included) or
equivalent. Refer to Figure 11.
b. While supporting lower front access panel,
remove two screws from bottom edge of panel
and remove panel. Refer to Figure 9.
c. Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 12.
d. Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 14.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to the right or left of spring.
e. Grasp loading door seal lip. Refer to Figure 15,
Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
f. Using a circular motion, pull seal up
(Figure 15, Step 1), out (Figure 15, Step 2) and
down (Figure 15, Step 3).
Figure 18
H212SE1A
DOOR BEZEL
ATTACHING
SCREW
INNER
DOOR AND
GLASS
DOOR
BEZEL
HINGE
ASSEMBLY
NUT
LOCKWASHER
DOOR
AND
GLASS
SCREW
