800793
45
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: Door seal hose and wire harness must be
reinstalled in the appropriate clips and holes along
top flange of front panel. Refer to Figure 16.
g. Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 14.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to the right or left of spring.
h. Grasp loading door seal lip. Refer to Figure 15,
Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
i. Using a circular motion, pull seal up
(Figure 15, Step 1), out (Figure 15, Step 2) and
down (Figure 15, Step 3).
j. When seal releases from lip of front panel, pull
out and remove the seal. Refer to Figure 15,
Step 4.
NOTE: The ease of installation of the loading door
seal can be improved using water or 409 lubricant to
work seal around circumference of loading door. Be
sure to orientate seal with the white arrow in the 12
o’clock position when installing the wire clamp ring
to front panel. Be careful not to overstretch tension
spring.
k. For all models except LTS85A*H, remove two
screws holding front panel to washer cabinet.
l. Remove front panel (with loading door
attached) away from washer as far as wires
permit.
Figure 14
;
;
H205S
WIRE
CLAMP
RING
SCREW
SPRING
SCREW
DOOR
SEAL
