Vending
33
512681
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5. Install coin slide extension assembly onto top of
coin slide using two remaining screws and
lockwashers. Refer to
Figure 37
.
6. Before installing coin slide extension, make sure
ground wire is tucked under control shield to
provide clearance for coin slide. Refer to
Figure 38
.
Installing Extension Onto Coin Slide:
Option 1
1. Insert coins and partially extend coin slide.
2. Insert coin slide on its side through meter case
opening. Then rotate 90 degrees to its proper
orientation.
3. Return coin slide and hook slide pins onto meter
case.
4. Continue coin slide installation according to
manufacturer’s instructions.
5. Check to make sure coin slide is operating
properly by inserting coins and starting a cycle.
The IN USE light will turn on, or flash if it is
already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes
factory default) when testing operation, refer to
Test Setting
section.
Figure 36
Figure 37
Coin Slide Bracket -
Letter "A"
Extension Bracket and
Lever Assembly
TLW2155N
Coin Slide Extension
Assembly
TLW2156N
TLW2157N
Figure 38
Ground Wire Placement
