Alliance Laundry Systems AES17AWF, Service

Page: 41 / 82

512176
39
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
43. DOOR HINGE
a. Open loading door and, while supporting door,
remove four screws holding door assembly to
hinges. Refer to
Figure 19 .
b. Remove four screws holding hinges to front
panel. Refer to Figure 19 .
44. HOLD-DOWN CLIPS AND LOCATORS
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to
Figure 8 .
b. Gently lower access panel to disengage panel
locators from bottom edge of front panel. Refer
to
Figure 17 .
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 9 . Swing bottom edge of front panel
away from dryer far enough to disengage hold-
down clips and panel locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 16 .
NOTE: Refer to wiring diagram when rewiring
switch.
e. Compress hold-down clips and remove from
top of front panel. Refer to Figure 17 .
f. Remove four screws holding four locators to
access panel or front panel. Refer to Figure 17 .
Figure 19
D306S
Lint Filter
Attaching
Screw
Door
Hinges
Door
Attaching
Screws
Lint
Filter