Alliance Laundry Systems AES17AWF, Service

Page: 35 / 82

512176
33
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
34. INNER AND OUTER DOOR PANELS AND
DOOR PULL
a. Remove four screws holding door assembly to
hinges. Refer to Figure 12 .
b. Remove remaining screws around the door
assembly and separate panels. Refer to
Figure 13 .
c. Remove wedge (located behind door pull) by
carefully prying up on center of wedge. Refer to
Figure 13 .
d. Remove door pull. Refer to Figure 13 .
35. DOOR STRIKE
a. Open loading door.
b. Remove screw holding door strike and bracket
to loading door and remove strike and bracket.
Refer to
Figure 13 .
NOTE: You may have to loosen the two screws on
end of door to allow for strike and bracket removal.
Figure 13
D343P
Door
Seal
Inner Door Panel
and Seal Assembly
Front
Panel
Door Hinge
Screw
Outer Door
Panel
Door
Pull
Wedge
Door Strike
Bracket
Door
Strike
Screw
Screws
Screw
Screw