Alliance Laundry Systems AES17AWF, Service

Page: 40 / 82

38
512176
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
41. CYLINDER LIGHT
Refer to Figure 18 .
a. Open loading door and remove screw holding
lens to front bulkhead.
b. Turn bulb counterclockwise and twist out of
light receptacle.
42. CYLINDER LIGHT RECEPTACLE
Refer to Figure 18 .
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to
Figure 8 .
b. Gently lower access panel to disengage panel
locators from bottom edge of front panel. Refer
to
Figure 17 .
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 9 . Swing bottom of front panel away
from dryer far enough to disengage hold-down
clips and locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 16 .
NOTE: Refer to wiring diagram when rewiring
switch.
e. Remove screw holding lens to front bulkhead.
f. Disconnect wires from light receptacle
terminals.
NOTE: Refer to wiring diagram when rewiring
receptacle terminals.
g. Unsnap and lift light receptacle out of front
bulkhead.
Figure 18
DRY1821S