allen MP245, Operations & Parts Manual

Page: 35 / 106

SECTION 1
SAFETY
067975
Page 35
Use the appropriate set of jacks that are designed for the machine you
are lifting.
STEP 1: Attach the front and rear dolly jacks into the machine at the receiving
tube locations.
STEP 2: Slowly lift machine in a safe manner to a height that is required to
safely install the pans. This is typically 6-8” above floor level.
STEP 3: Carefully slide the pans under the machine making sure that you are
aware of the corners on the blades that are sharp. (B)
STEP 4: Align the pans so that the clips will not be crushed when the machine
is lowered back down.
STEP 5:
Slowly lower the machine down onto the pans while maintaining a
visual so the blades are going into the proper gaps. (Typically the pans can
only be intalled one way)
STEP 6:
Remove lifting bridle from the machine.
STEP 7: Start machine and slowly increase the throttle until the blades slowly
begin turning and engaging the pans. The machine is now ready to finish con -
crete utilizing the pans.
NOTE: Utilizing the lifting sling(bridle) and the dolly jacks are intended only for
site transportation and the installation of pans and blades. DO NOT use them
for regular maintenance without the additional use of jack stands to insure
stability of the machine.
Pan Installation Instructions (cont’d)