Allen-Bradley PowerFlex 20-comm-c FRN 1. Series, User Manual

Page: 32 / 159

3-8 Configuring the Adapter
When you enter 1 = Reset Module , the adapter will be immediately
reset. When you enter 2 = Set Defaults , the adapter will set all adapter
parameters to their factory-default settings. The value of this parameter
will be restored to
0 = Ready after performing the reset or setting the
defaults. A “Reset Module” should be performed after performing a “Set
Defaults”.
The following parameters provide information about how the adapter is
configured. You can view these parameters at any time.
Viewing the Adapter Configuration
Parameter
No. Name and Description
Details
01 [DPI Port]
Port to which the adapter is connected. This will
usually be port 5.
Default: 5
Minimum: 0
Maximum: 7
Type: Read Only
02 [DPI Data Rate]
Data rate used by the drive. This data rate is set in
the drive, and the adapter detects it.
Default: 0 = 125 K
Values: 0 = 125 K
1 = 500 K
Type: Read Only
04 [CN Addr Act]
The actual Network Node Address.
Default: 2
Minimum: 1
Maximum: 99
Type: Read Only
06 [CN Rate Act]
The Actual Network Data Rate
Default: 0 = 5 Mbps
Values: 0 = 5 Mbps
Type: Read Only
07 [Ref / Fdbk Size]
Size of the Reference/Feedback. The drive
determines the size of the Reference/Feedback.
Default: 0 = 16-bit
Values: 0 = 16-bit
1 = 32-bit
Type: Read Only
08 [Datalink size]
Size of each Datalink word. The drive determines
the size of Datalinks.
Default: 0 = 16-bit
Values: 0 = 16-bit
1 = 32-bit
Type: Read Only
Reset Required: No
14 [DPI I/O Active]
I/O that the adapter is actively transmitting. The
value of this parameter will usually be equal to the
value of Parameter 13 - DPI I/O Config.
Default: xxx0 0001
Bit Values: 0 = I/O disabled
1 = I/O enabled
Type: Read Only
Bit Definitions
0 = Cmd/Ref
1 = Datalink A
2 = Datalink B
3 = Datalink C
4 = Datalink D
5 = Not Used
6 = Not Used
7 = Not Used
Bit
Default
1 0 0 0 0 x x x
20COMM-UM003A-EN-P.book Page 8 Wednesday, November 7, 2001 3:46 PM