Allen-Bradley PowerFlex 20-comm-c FRN 1. Series, User Manual

Page: 15 / 159

Getting Started 1-5
This section is designed to help experienced users configure or set up the
ControlNet adapter. If you are unsure about how to complete a step, refer
to the referenced chapter.
!
ATTENTION: Risk of injury or equipment damage exists. The
examples in this publication are intended solely for purposes of
example. There are many variables and requirements with any
application. Rockwell Automation does not assume responsibility or
liability (to include intellectual property liability) for actual use of the
examples shown in this publication.
Quick Start
Step Refer to
1 Review the safety precautions for the adapter. Throughout This
Manual
2 Verify that the PowerFlex drive is properly installed. Drive User Manual
3 Install the adapter.
Verify that the PowerFlex drive is not powered. Then,
connect the adapter to the network using a ControlNet cable
and to the drive using the Internal Interface cable. Use the
captive screws to secure and ground the adapter to the
drive.
Chapter 2 ,
Installing the
Adapter
4 Apply power to the adapter.
The adapter receives power from the drive. Apply power to
the drive. The status indicators should be green. If they flash
red, there is a problem. Refer to
Chapter 7 , Troubleshooting .
Chapter 2 ,
Installing the
Adapter
5 Configure the adapter for your application.
Set the parameters for the following features as required by
your application:
•
I/O configuration.
•
Fault actions.
Chapter 3 ,
Configuring the
Adapter
6 Apply power to the ControlNet master and other
devices on the network.
Verify that the master and network are installed and
functioning in accordance with ControlNet standards, and
then apply power to them.
7 Configure the scanner to communicate with the
adapter.
Use a network tool for ControlNet to configure the master on
the network.
Chapter 4 ,
RSNetWorx
Configuration for
PLC-5C
Applications
8 Create a ladder logic program.
Use a programming tool to create a ladder logic program
that enables you to do the following:
•
Control the adapter and connected drive.
•
Monitor or configure the drive using Explicit Messages.
Chapter 5 ,
PLC-5C
Applications
Chapter 6 ,
ControlLogix
Applications
20COMM-UM003A-EN-P.book Page 5 Wednesday, November 7, 2001 3:46 PM
Spare Allen-Bradley Parts