Allen-Bradley InView Marquee 2706-P42, User Manual

Page: 99 / 212

Publication 2706-UM016A-EN-P - June 2002
EtherNet/IP Communications 6-11
Using a ControlLogix with
1756 – ENET Card to a
InView Display
Below is the setup for the ENI.
1. The first thing to do when setting up to use the ControlLogix is
to open a new application.
2. Then set up the controller properties.
•
The serial configuration can be left as the default because the
DF1 port will not be used. Instead under the I / O
Configuration folder, an Ethernet module will need to be
created. This is done by right-clicking the folder and choosing
new.
•
In the module properties screen shown below, the module
must be given a name, told what slot the 1756 – ENET
module resides in, and the modules IP address.
TIP
The examples below are one way to trigger
messages in the InView using Ethernet Protocol and
a single ENI configuration.
Allen-Bradley Spares