Allen-Bradley InView Marquee 2706-P42, User Manual

Page: 94 / 212

Publication 2706-UM016A-EN-P - June 2002
6-6 EtherNet/IP Communications
N7:0 is the message number you wish to trigger in the Inview Display.
It gets converted into a String file type ST11:4. Rung 1 then takes
ST11:3 (which is either ^T or ^V) and adds it to ST11:4 and puts it into
ST11:2. ST11:2 is then added to ST11:5 (which is ^M) in rung 2 and
puts it into ST11:0 which will be the string file that is sent out the MSG
function in rung 3. This is shown in the properties of the ST11 data
type below:
4. Under the Message setup as shown below, the port must be
assigned to 3A. This is the Ethernet sidecar port. Also the
multihop MUST be Yes.
5. Under the Multihop tab, the IP address shown is the IP address
of the ENI module. The setup for the MSG function is as follows:
TIP
To do Multihop messaging, you need a series E,
revision D.1 or later Ethernet PLC-5 processor or any
series E, revision D or later PLC-5 processor with a
series B, revision A 1785-ENET interface module.