Allen-Bradley 1783-WAPAK9, User Manual

Page: 583 / 612

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 583
Error and Event Messages Appendix C
Association Management
Messages
This table explains error message that are related to association management.
Unzip Messages
This table explains the error message for Unzip.
Table 3 - Association Management Messages
Message Explanation Recommended Action
DOT11-3-BADSTATE: “%s %s ->%s.”
802.11 association and management uses a table-
driven state machine to keep track and transition an
association through various states. A state transition
occurs when an association receives one of many
possible events. When this error occurs, it means that
an association received an event that it did not expect
while in this state. The system can continue but can lose the association that
generates this error. Copy the message exactly as it appears and
report it to your technical service representative.
DOT11-6-ASSOC: “Interface %s,
Station %s e% %s KEY_MGMT (%s),
MSGDEF_LIMIT_MEDIUM.”
The indicated station associated to an access point on
the indicated interface. None.
DOT11-6-ADD: “Interface %s,
Station %e associated to parent
%e.”
The indicated station associated to the parent access
point on the indicated interface. None.
DOT11-6-DISASSOC: Interface %s,
Deauthenticating Station %e #s
Station disassociated from the access point. No action is required.
DOT11-6-ROAMED: “Station %e
roamed to %e.”
The indicated station roamed to the indicated new
access point. None.
DOT11-4-ENCRYPT_MISMATCH:
“Possible encryption key
mismatch between interface %s
and station %e.”
The encryption setting of the indicated interface and
indicated station can be mismatched. Check the encryption configuration of this interface and the
failing station to verify that the configurations match.
DOT11-4-DIVER_USED: Interface
$s, Mcs rates 8-15 disabled due
to only one transmit or recieve
antenna enabled
These rates require that at least 2 receive and transmit
antennas be enabled. Copy the error message exactly as it appears on the console or in
the system log. Research and attempt to resolve the error by
using the Output Interpreter
https://www.cisco.com/cgi-bin/
Support/OutputInterpreter/home.pl
Also perform a search of the Bug Toolkit http://www.cisco.com/
cgi-bin/Support/Bugtool/home.pl .
DOT11-4-NO_HT: Interface %s, Mcs
rates disabled on vlan %d due to
%s
The correct configuration was not in use to allow the
HT rates to be used. Copy the error message exactly as it appears on the console or in
the system log. Research and attempt to resolve the error by
using the Output Interpreter
https://www.cisco.com/cgi-bin/
Support/OutputInterpreter/home.pl.
Also perform a search of the Bug Toolkit http://www.cisco.com/
cgi-bin/Support/Bugtool/home.pl .
DOT11-4-NO_MBSSID_BACKUP_VLAN:
Backup VLANs cannot be
configured if MBSSID is not
enabled:"$s" not started
To enable backup VLAN, configure the MBSSID mode. Configure MBSSID on the device.
Table 4 - Unzip Messages
Message Explanation Recommended Action
SOAP-4-UNZIP_OVERFLOW: “Failed
to unzip %s, exceeds maximum
uncompressed html size.”
The HTTP server cannot retrieve a compressed file in
response to an HTTP GET request because the file is
too large for the buffers used in the uncompression
process. Make sure that the file is a valid HTML page. If it is, you need to
copy an uncompressed version of the file into flash memory to
retrieve it through HTTP.