Allen-Bradley 1783-WAPAK9, User Manual

Page: 196 / 612

196 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 5 Configure the Stratix 5100 WAP Using the Command-Line Interface
ap1240AG(config-dot1x-creden)#username Rockwell
ap1240AG(config-dot1x-creden)#password wirelessap
ap1240AG(config-dot1x-creden)#exit
ap1240AG(config)#
Applying the Credentials to an Interface or SSID
Credential profiles are applied to an interface or an SSID in the same way. SSID
Manger Page on page 116
Applying the Credentials Profile to the Wired Port
Beginning in the privileged EXEC mode, follow these steps to apply the
credentials to the access point wired port:
1.
Enter global configuration mode.
configure terminal
2.
Enter the interface configuration mode for the access point Fast Ethernet
port.
You can also use interface fa0 to enter the fast Ethernet configuration
mode.
interface fastethernet 0
3.
Enter the name of a previously created credentials profile.
dot1x credentials profile name]
4.
Return to the privileged EXEC mode
end
5.
Save your entries in the configuration file. This is optional.
copy running config startup-config
The following example applies the credentials profile test to the access point Fast
Ethernet port:
ap1240AG>enable
Password:xxxxxxx
ap1240AG#config terminal
Enter configuration commands, one per line. End
with CTRL-Z.
ap1240AG(config)#interface fa0
ap1240AG(config-if)#dot1x credentials test
ap1240AG(config-if)#end
ap1240AG#