Allen-Bradley 1783-WAPAK9, User Manual

Page: 500 / 612

500 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 18 Configuring CDP
Configuring CDP This section contains CDP configuration information and procedures:
Default CDP Configuration
This table lists the default CDP settings.
Configuring the CDP Characteristics
You can configure the CDP holdtime (the number of seconds before the access
point discards CDP packets) and the CDP timer (the number of seconds
between each CDP packets the access point sends).
Beginning in Privileged Exec mode, follow these steps to configure the CDP
holdtime and CDP timer.
1.
Enter global configuration mode.
configure terminal
2.
(Optional) Specify the amount of time you want a receiving device to hold
the information sent by the device before discarding it.
The range is from 10…255 s; the default is 180 s.
cdp holdtime seconds
3.
(Optional) Set the transmission frequency of CDP updates in seconds.
The range is from 5…254 s; the default is 60 s.
cdp timer seconds
4.
Return to Privileged Exec mode.
end
Use the
no
form of the CDP commands to return to the default settings.
This example shows how to configure and verify CDP characteristics:
AP# configure terminal
AP(config)# cdp holdtime 120
AP(config)# cdp timer 50
AP(config)# end
Table 108 - Default CDP Configuration
Feature Default Setting
CDP global state Enabled
CDP interface state Enabled
CDP holdtime (packet holdtime in seconds) 180
CDP timer (packets sent every x seconds) 60