HERA Series CD/DVD Duplication System / User Manual
37
Duplicator B.30
16. AUTOCOPY
Loader Processing...
Please Wait
Loader Processing
Drive 1<-Input Bin
Loading... RESERVED
60% 4012MB
Loader Processing
Drive 2<-Input Bin
Processing...
Please Wait
Copying... H4012MB
0 12%
Use the
Up or
Down
button to select whether the
AUTOCOPY Enabled
function is on or off, and
press the
Enter
button to select that option.
Once you get back to the main menu, use the
Up or
Down
button to navigate to the following
screen:
Fill the input spindle(s) with the required number of blank discs.
Place the Master disc on top of the stack in the first input spin-
dle, and press the
Enter
button to start the AUTOCOPY
process.
The loader will then start the Autocopy process.
The loader will load the Master into the next available drive.
The loader will load the contents of the master disc into the
RESERVED partition.
Once the content of the master disc has been loaded, the autoloader removes it from the drive, places
it on the output spindle, and starts placing blank discs into the writer drives.
This information screen shows what is happening. In this case,
the loader has taken a disc from the input spindle and is placing it
into Drive 2.
The loader will continue to remove discs from the input spindle and place them into drives until either
all of the drives are full, or until it runs out of blank discs.
It takes a few seconds for the autoloader to recognize all the
discs.
After two or three seconds of processing time, the following
Copy Progress
screen will appear.
“H” indicates the source of the job resides in the Hard
Drive.
“4012MB” indicates the capacity of the master disc.
“12%” indicates the current progress of the duplication.
“0” indicates you have made 0 copies so far.
Note:
It is normal to see the progress indicator stay at 0% - 10% and 100% for approximately 30
seconds for CD duplication and up to one minute for DVD duplication. That is caused by the
initializing and finalizing stages.
Once the duplication run is completed, the loader will remove the disc from the drive and will place
either the successful copy on the output spindle or the bad copy in the reject area.
