ALL POWER AMERICA PW3200, Owner'S Manual

Page: 9 / 24

ALL POWER™ PW3200 PRESSURE WASHER | 9
The Pressure Washer comes furnished with five
spray nozzles. Each nozzle is color coded and
delivers a specific spray pattern and pressure
for a particular cleaning job. The size of the
nozzle determines the size of the fan spray and
the pressure out of the nozzle.
0° Nozzle - Red: Cutting
This nozzle delivers a pinpoint stream of
pressurized water and is extremely powerful.
It covers only a small area of cleaning. This
nozzle should only be directed at surfaces that
can withstand high pressure such as metal
or concrete. Do not use this nozzle to clean
wood.
15° Nozzle - Yellow: Chiseling
This nozzle delivers a powerful 15 degree
spray pattern for intense cleaning of small
areas. This nozzle should only be used on areas
and materials that can withstand high pressure.
25° Nozzle - Green: Flushing
This nozzle delivers a 25 degree spray pattern
for intense cleaning of larger areas. This
nozzle should only be used on areas that can
withstand pressure from this nozzle.
40° Nozzle - White: Washing
This nozzle delivers a 40 degree spray pattern
and a less powerful stream of water. This
nozzle can cover a wide area and should be
used for most general cleaning jobs.
Chemical Nozzle - Black: Detergent
Application
This nozzle is used to apply special chemicals
and cleaning solutions. This nozzle produces
the weakest pressure stream of the five nozzles.
CONNECTING NOZZLES TO
SPRAY WAND
Never place hands in front of nozzle.
Never grasp hose or fittings during
Pressure Washer operation. Never attempt
to attach or remove spray wand or hose
fittings while Pressure Washer system is
pressurized. Turn off Pressure Washer and
lock the Gun Trigger before attempting to
change pressure nozzles.
WARNING
1. To attach, insert nozzle into female
quick-disconnect spray wand and press to
snap in the nozzle.
2. To detach, slide down slip ring on female
quick-disconnect to eject the nozzle.
CONNECTING WATER SUPPLY TO PUMP
1. Connect the garden hose to the water
supply and turn water supply on to fill the
hose with water and also remove any
debris in the hose. Turn OFF water supply.
2. Make sure that the filter inside Pressure
Washer water inlet is clean and
undamaged. Thread the garden hose
fitting into water hose inlet. FIRMLY hand
tighten the inlet nut.
3. Turn on water supply.
NOTE: The Pressure Washer requires a
minimum of 20 PSI and flow rate of
4 GPM.
OWNER’S MANUAL | INSTALLATION 9