ALL POWER AMERICA PW3200, Owner'S Manual

Page: 11 / 24

ALL POWER™ PW3200 PRESSURE WASHER | 11
Start-up Procedure
1. Make sure water supply is connected
and turned on.
2. Release gun safety if locked.
3. To allow air to escape from the hose,
squeeze trigger on the gun until there is
a steady flow of water coming out from
the nozzle.
Starting Engine
1. Check oil and gas.
2. Connect hose and turn on water.
3. Squeeze and hold trigger.
4. Make sure the engine switch is on the
ON position (Fig 1).
Fig 1. Engine Switch
Starting Engine (cont’d)
Fig 2. Fuel Valve
Fig 3. Choke
5. Set the fuel valve to open (Fig 2).
6. Set choke to CLOSE position (Fig 3)
& set throttle to slow (Fig 4).
Fig 4. Throttle Control
(Fig 1)
7. When starting engine, pull cord slowly until
resistance is felt, then pull rapidly.
8. If engines starts and fails to continue
running or if increase resistance is felt
during starting pull attempts, repeat
step 3 - 7.
The pressure washer can be used for a variety
of applications including washing cars, boats,
patios, decks, garages etc. where high pressure is
necessary to remove dirt and debris. High-pressure
water flow can damage the work surface if not
used properly! See the section titled “Operating
Instructions” for more details. Always test the
spray in an open area first.
CAUTION
OWNER’S MANUAL | OPERATION 11