ALL POWER AMERICA PW3200, Owner'S Manual

Page: 16 / 24

16 | ALL POWER™ PW3200 PRESSURE WASHER www.allpoweramerica.com
Problem Probable Cause Solution
Engine will not start
Low oil shutdown Fill engine with oil
Engine switch not in “ON” position Turn engine switch to the “ON” position
Pressure built up in hose Squeeze trigger while starting
Engine is overloaded
Nozzle partially blocked Clean nozzle
Excessive pressure Shorten the spring coil on the reflux valve
Pressure increases when gun is locked Bypass valve blocking Clean the bypass valve
Engine is running but pump won’t
build maximum pressure or has
irregular pressure.
Faucet closed partially Open faucet fully
Unit has been stored in freezing temperatures Thaw out unit completely
Inadequate water supply Provide a minimum of 4 GPM at 20 PSI
Water inlet screen clogged Clean screen
Kink in garden hose Straighten garden hose
Wand nozzle worn or damaged Replace nozzle
Air in pump
Run with gun open & wand removed until steady
stream of water is released.
Adjustable pressure knob not set to maximum position Set to maximum position
Suction or discharge valves clogged or worn out
Clean the suction or discharge valves
Bypass valve not operating effectively Clean the bypass valve
TROUBLESHOOTING GUIDE
The following troubleshooting guide is recommended for basic or
common problems; if there’s an issue with the Pressure Washer that is
not listed, please call 1-888-896-6881.
NOTE: Troubleshooting problems may have similar causes
and solutions.
16 TROUBLESHOOTING | OWNER’S MANUAL