ALL POWER AMERICA PW3200, Owner'S Manual

Page: 8 / 24

8 | ALL POWER™ PW3200 PRESSURE WASHER www.allpoweramerica.com
Installing the Wheel kit
1. Before adding oil to the engine, carefully
tip the pressure washer forward and
place on its front side.
2. Slide the axle through the washer and
front of wheel.
3. Slide another washer to the back of
wheel and through the mount point on
the frame.
4. Repeat steps 2 and 3 to attach the
second wheel.
5. Assemble the handle to the frame
tubing.
NOTE: Align threaded connections
carefully to prevent damaging threads
during assembly. Tighten connections
securely to prevent leaks during
operation.
PRESSURE HOSE TO PUMP
Connect the pressure hose to the pump
outlet and FIRMLY tighten the nut by hand.
NOTE: Do not use pressure hose from
another manufacturer.
PRESSURE HOSE TO SPRAY GUN
Connect the hose to the spray gun and FIRMLY
tighten the nut by hand.
8
Owner’s Manual
Operating Connections
HIGH PRESSURE HOSE
• Attach the high pressure hose to the pressure washer by pulling back on the collar of
the quick-connect coupling on the hose and pushing it over the coupling half on the
pressure washer outlet.
NOTE: Do not use pressure hose from another manufacturer.
WATER CONNECTION
Before connecting the garden hose to your pressure washer, run water through the
garden hose (not supplied) to flush out any foreign matter.
• Attach garden hose quick-connect to the garden hose (see below).
• Then attach that to the quick-connect inlet on the pressure washer pump. Make sure
it locks into place by pulling back on the garden hose quick-connect collar and
inserting it into the quick-connect inlet.
NOTE: The water supply must supply a minimum of 4 gpm at 20 PSI, or the pump
can be damaged.
PRESSURE WASHER PUMP
High Pressure Hose
Garden Hose
Quick-Connect
Thermal Relieve
Valve Connection
Garden
Hose
Detergent
Connection
Quick-Connect Inlet
9
Owner’s Manual
Operating Instructions
Start-up Procedure
1. Make sure water supply is connected and turned on.
2. Release gun safety if locked.
3. To allow air to escape from the hose, squeeze trigger on the gun until there is a
steady flow of water coming out from the nozzle.
Starting Engine
1. Check oil and gas.
2. Connect hose and turn on water.
3. Squeeze trigger.
4. Make sure the engine switch is on the ON position
(illustration 1) .
5. Set the fuel valve to open
(illustration 2)
.
6. Set choke to CLOSE position (illustration 3) & set throttle to slow (illustration 4) .
7. When starting engine, pull cord slowly until resistence is felt, then pull rapidly.
8. If engines starts and fails to continue running or if increase resistance is felt during
starting pull attemps repeat step 3 - 7.
4) Throttle Control
1) ON/OFF Switch
2) Fuel Valve
3) Choke
CONNECTING SPRAY WAND TO
SPRAY GUN
Remove the protective plastic cap at the inlet
of the wand.
Connect the spray wand to the spray gun and
FIRMLY tighten the nut by hand.
SELECTING THE RIGHT NOZZLE
NOTE: To prevent damage to your surface
and to select an appropriate nozzle size for
your application, always start with lowest
pressure nozzle size (White) and continue
changing to the higher nozzle size until the
best work result is achieved.
8 INSTALLATION | OWNER’S MANUAL