26
25
RADIO RECEIVER CONNECTION
3
2
1
3 = 24 VDC
2 = RELAY
1 = COMMON
RECEIVER TERMINAL STRIP
LOCATED OUTSIDE OF
THE CONTROL BOX
There are two types of receivers: 3-wire and 4-wire:
3 wire receivers can mount on the radio receiver terminal strip located outside of the control box.
For 4 wire receivers, connect the 2 gray wires to terminals 1 and 2 on the receiver terminal strip located outside
of the control box. Connect the black wire to the 24V-COM and the red wire to the 24 VDC on the board terminal
strip as shown below.
RADIO dip switch ON allows the radio receiver to override the automatic close timer.
4-WIRE 24VAC
RADIO RECEIVER
3 WIRE 24VAC
RADIO RECEIVER
MAGNETIC/SOLENOID LOCK CONNECTION
1 2 3 4 5 6 7 8
-----------------------OPEN------------------------
TIMER
RADIO
OSC
LOCK
1-PASS
SLAVE
BRAKE
OPEN L/R
OFF ON
FOR MAGNETIC LOCK, SET “LOCK”
DIP SWITCH TO THE “ON” POSITION
FOR SOLENOID LOCK, SET “LOCK”
DIP SWITCH TO THE “OFF” POSITION
MAG
LOCK
SOLENOID
LOCK
STEP DOWN
TRANSFORMER
A magnetic lock installation
requires a step down transformer
with appropriate voltage specific to the lock
accessory and two wires.
When using a magnetic lock, the LOCK dip switch (#4) must be turned ON. The “LOCK OUTPUT” LED will turn
on to show the lock is magnetized.
When using a solenoid lock, the LOCK dip switch (#4) must be turned OFF.
AC-N
and
LOCK
from the board terminal strip supply 120 VAC to power the transformer and control the lock.
Connect low voltage wires from the transformer directly to the lock, as shown below.
Connecting the mag lock
straight to the board will cause damage to the board and mag lock.
