
30
6. Operating Modes
6
6-1 Setting frequencies in VFO mode
The VFO mode is a mode displayed when you turn ON the DJ-X11 for the
fi
rst
time with the factory default setting. In this mode, you can select receiving fre-
quencies by rotating the dial.
●
Switching between bands
Pressing the
or
key will select the band.
6-2 Setting the Channel Step Frequency
A channel step refers to the interval between the frequencies which have been
assigned to radio communications and broadcasts. Although the typical steps
have been programmed in the DJ-X11, you can change the steps as necessary.
For the procedure, refer to “Changing the Channel Step” (P. 58).
6-3 1 MHz UP/DOWN Operation
●
Changing the frequency of the main band in larger increments
In VFO mode, select the main band, hold down the [FUNC] key and rotate
the upper main dial. The frequency increases or decreases in units of 1
MHz.
●
Changing the frequency of the sub band in larger increments
In VFO mode, select the sub band, hold down the [FUNC] key and rotate
the upper sub dial. The frequency increases or decreases in units of 1
MHz.
MEMO
• The 1 MHz UP/DOWN operation increases or decreases the frequency
regardless of the frequency range of the band.
• When the [FUNC] key is held down but the dial is not rotated for ap-
proximately one second, the Key-lock will be activated.
• When using the 1 MHz UP/DOWN operation, the display may some-
times jump to an unexpected frequency due to the channel step setting.