46
14.1 Use Scissors (DYN2511) and/or a sharp Hobby Knife (EXL16001) to carefully remove plastic from the
back, windshield area and vent holes on the side/bottom of the canopy on the molded cut lines. You
will also need to remove the plastic along the molded cut line around the windshield.
14.2 Use clear tape or small self-tapping screws from the Spare Hardware Parts Bag to fasten the
windshield to the canopy.
14.3 Insert the canopy mounting grommets (found in the Cable/Zip Tie and Canopy Mounting Grommet
Parts Bag) in the holes on each side of the canopy.
14.4 Apply the included decals on the canopy, horizontal and vertical fins using the images found on the
box for reference.
14.5 The canopy is installed on the model by first placing its bottom under the forward extending “ledge”
of the main frame base plate. Then, place the grommets onto the canopy mounts found just behind
the main shaft and near the top of the upper frames.
Note: If you find that any of the control linkages bind against the canopy once it is
installed, be sure to remove additional plastic material from the canopy until the
binding no longer occurs.
14.0 Canopy and Windshield Assembly
and Installation
Summary of Contents for T-REX 450SA ARF
Page 70: ...70 Building Notes ...
Page 71: ...71 Flying Notes ...
