16
One sub-micro, micro or mini servo (with a .12 sec/60° or faster transit speed) is required for tail control.
2.1
Install the tail rotor servo on the tail boom servo mounts using two of the remaining servo mounting
screws. If you are installing the JR 3400G servo, be sure to also use two of the blue anodized
aluminum cap washers from the Spare Hardware Parts Bag. Note that the output shaft of the servo
must be oriented toward the rear of the helicopter.
2.2
Leave the tail boom servo mounts loose on the boom at this time, as the servo and mount positions
will be adjusted later on.
2.0 Tail Servo Installation
Summary of Contents for T-REX 450SA ARF
Page 70: ...70 Building Notes ...
Page 71: ...71 Flying Notes ...
