Replacing the Logo Board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before Working Inside Your Computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1. Align the screw holes on the logo board to the screw holes on the bracket and slide the logo board in.
2. Replace the screws that secure the logo board to the bracket.
3. Slide the logo board inside the chassis.
4. Replace the screw that secure the logo board to the bracket.
5. Route and connect the cables that you removed from the connectors on the logo board.
Post-requisites
1. Replace both the left and right side-panels. See “
”.
2. Replace the
78
Summary of Contents for Area-51 ALX
