Replacing the Drive-Bay Heat-Sensor
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before Working Inside Your Computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1. Reroute the drive-bay heat-sensor in the sensor bracket.
2. Align the drive-bay heat-sensor in the securing clip.
3. Close and press the release tab on the securing clip.
4. Lay the chassis on the left side.
5. Connect the drive-bay heat-sensor cable to the connector on the system board. See “
”.
Post-requisites
1. Replace both the left and right side-panels. See “
”.
2. Replace the
43
Summary of Contents for Area-51 ALX
