Replacing the Memory Module(s)
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before Working Inside Your Computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1. Align the notch on the bottom of the memory module with the tab on the memory-module slot.
2. Insert the memory module into the memory-module connector until the memory module snaps into position and the securing clips
lock in place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
a. memory module
b. memory-module slot
c. notch
Post-requisites
1. Remove both the left and right side-panels. See “
”.
2. Replace the
45
Summary of Contents for Area-51 ALX
