3 of 19
JACKBEAM INSTALLATION AND OPERATION MANUAL
The Jackbeam should only be used with lifts installed on level concrete floors conforming to the
installation instructions for the lift. Consult lift installation instructions for concrete thickness and
strength requirements. Ensure clearance around and above lift conforms to installation instructions
for the lift.
ATTENTION!
This lift is intended for indoor installation only. It is prohibited
to install this product outdoors. Operating environment temperature range
should be 41 – 104 °F (5 – 40 °C). Failure to adhere will result in
decertification, loss of warranty, and possible damage to the equipment.
Installation of lifts shall be performed in accordance with ANSO/ALI ALIS, Safety Requirements for
Installation and Service of Automotive Lifts
For additional safety instructions regarding lifting, lift types, warning labels, preparing to lift, vehicle
spotting, vehicle lifting, maintaining load stability, emergency procedures, vehicle lowering, lift
limitations, lift maintenance, good shop practices, installation, operator training and owner/employer
responsibilities, please refer to “Lifting It Right” (ALI/SM) and “Safety Tips” (ALI/ST).
For additional instruction on general requirements for lift operation, please refer to “Automotive Lift-
Safety Requirements For Operation, Inspection and Maintenance” (ANSI/ALI ALOIM).
NOTE: Air supply must be lubricated and include water separator. Failure to do so will
damage the air /hydraulic motor and void the manufacturer’s warranty.
