Operation instructions
SELECTOR
The controls featured in this manual are representative of many
available models. Your model may offer slightly different features.
Cool Mode
The desired cool setting is selected by rotating the knob to the right to
the appropriate location.
HIGH COOL
has maximum cooling effect and airflow.
MED COOL
has the intermediate cooling effect and airflow.
LOW COOL
has minimum cooling effect and airflow.
HIGH HEAT
has maximum heating effect and airflow.
LOW HEAT
has minimum heating effect and airflow.
OFF
will completely shut off the unit.
Fan Mode
Rotate the knob to the left to select your choice of fan speeds for air
circulation.
HIGH FAN
permits high fan speed operation without cooling effect.
MED FAN
permits med fan speed operation without cooling effect.
LOW FAN
permits low fan speed operation without cooling effect.
Note:
When selecting a fan speed, the compressor will not run.
Note
THERMOSTAT
Cooling & Heating models
To set the desired room temperature, rotate the thermostat switch to the
desired setting. The temperature you are setting gets higher from
6
to
1
, lower from
6
to
12
. After the set temperature is achieved,
the thermostat will automatically start and stop the compressor in order to
maintain the desired set temperature.
Thermostat
The thermostat is used to set the desired room temperature when the unit
is being operated in the COOL MODE.
NOTE:
During the cooling operation of the unit, when the thermostat knob
is rotated clockwise, allow at least three minutes before turning back the
knob to the
COOLER
or
HEATER
direction. Otherwise the fuse may
blow due to an overload of the unit.
For the unit adopts PTC heater, when the SELECTOR is set to HIGH HEAT
or LOW HEAT, the THERMOSTAT is disabled. You cannot use the
THERMOSTAT to adjust the temperature.
1
12
9
6
3
HEATER
COOLER
Cooling only models
HIGH
HEAT
LOW
HEAT
LOW
FAN
HIGH
FAN
LOW
COOL
HIGH
COOL
Cooling & Heating models
Selector
LOW
COOL
HIGH
FAN
LOW
FAN
HIGH
COOL
MED
COOL
OFF
OFF
HIGH
COOL
MED
COOL
LOW
COOL
HIGH
FAN
MED
FAN
LOW
FAN
When turning the SELECTOR knob from "LOW COOL(HEAT)" to
"HIGH COOL(HEAT)", keep your speed slow as far as possible. Do
not change the operation mode from "LOW COOL(HEAT)" to "HIGH
COOL(HEAT) too often.
"
