Installation instructions
TREATMENT OF CONDENSED WATER
SEAL
DRAIN
JOINT
RUBBER
PLUG
To meet different requirement of different type of air conditioner,
there are two kinds of methods for your choice to treat the conden-
sed water.
For Cooling Only Models:
You can choose back drainage or non-drainage. See the following
procedures to perform back drainage:
1. Fit the seal onto the drain joint (which provided with your air
conditioner accessory).
2. Remove the rubber plug from the back of the unit.
3. Attach the drain joint to the back of the cabinet
where you remove the plug and rotate 90 to securely assemble
them.
4. Connect the drain joint with a extension drain hose (Locally
purchased)
O
For Cooling & Heating Models only:
You can choose bottom drainage . See the following procedures to
perform bottom drainage:
1. Remove the rubber plug from the bottom of the cabinet.
2. Take out the drain tray and screws (which provided with your air
conditioner accessory).
3. Install the drain tray at the bottom of the unit and secure with
screws provided.
4. Connect the drain hose to the outlet located at one side of the
drain tray. You can purchase the drain hose or tubing locally to
satisfy your particular needs (Drain hose is not supplied)
RUBBER
PLUG
SCREW
DRAIN TRAY
DRAIN
OUTLET
Installation Steps
Step 1. Remove the front panel and the air filter
1. Hold the slot under the front panel, then uplift it
outwards, and remove the front panel (See Fig.1).
2. Pinch the handle under the air filter and make the
air filter arched, remove it from the slot from
underside to upside (See Fig.2).
Fig.1
Fig.2
