Operation instructions
The control panel of the unit you purchased may look like one of the following:
Control Panel
Operation instr uctions
THERMOSTAT
To set the desired room temperature, rotate the thermostat switch to the
desired setting. After the set temperature is achieved the thermostat will
automatically start and stop the compressor in order to maintain the
desired set temperature.
Rotate the thermostat selector clockwise for higher cool settings. Higher
cool settings will provide lower room temperature. Rotate the thermostat
selector counter clockwise for lower cool settings. Lower cool settings will
provide higher room temperature.
The thermostat is used to set the desired room temperature when the
unit is being operated in the COOL MODE.
NOTE:
During the cooling operation of the unit, when the thermostat
knob is rotated clockwise, allow at least three minutes before turning
back the knob to the
1
direction. Otherwise the fuse may blow due
to an overload of the unit.
DO NOT
rotate the THERMOSTAT knob
beyond the range fron
1
to
12
.
Cooling only models
The controls featured in this manual are representative of many
available models. Your model may offer slightly different features.
3
6
9
1
12
COOLER
Cooling only models
Cooling & Heating models
OFF
ON
AUTO SWING
COOLER
1
6
3
9
THERMOSTAT
LOW
COOL
HIGH
FAN
LOW
FAN
HIGH
COOL
MED
COOL
OFF
SELECTOR
COMP.
WAIT THREE MINUTES BEFORE RESTARTING
THERMOSTAT
AUTO SWING
SELECTOR
OFF
ON
COMP.
COOLER
HIGH
COOL
MED
COOL
LOW
COOL
HIGH
FAN
MED
FAN
LOW
FAN
WAIT THREE MINUTES
BEFORE RESTARTING
OFF
SELECTOR
THERMOSTAT
AUTO SWING
1
12
9
6
3
WAIT T HREE M INUTES BEFORE R ESTARTING
HIGH
HEAT
LOW
HEAT
LOW
FAN
HIGH
FAN
LOW
COOL
HIGH
COOL
ON
OFF
COMP.
HEATER
COOLER
COMP. indicator: This indicator light shows the
status of the compressor. When the compressor starts up,
it lights on; when the compressor shuts down, it lights off.
