Manual
Timy3 - General
-28-
9.7 PROGRAM
This function allows switching to another Timy3-program.
ATTENTION:
When changing the program all saved times must be deleted!
9.8 Program Specific Settings
Depending on active program this menu item is different.
9.9
WTN
The
ALGE-TIMING
WTN is a radio network consisting of several devices of the
Within the network, devices can communicate with each other using other devices; i.e. the
communication is carried out from one device to another through a third one. The network is
intended for simultaneously transmitting display data (e.g. for
ALGE-TIMING
GAZ or D-LINE),
serial RS232 data (e.g. to a PC) and timing impulses.
The system is designed in such a way that the Timy3 is at the same time master and time
server. Therefore, you should pay attention to the following facts:
1. The Timy3 should always be switched on as first device so that all participants can syn-
chronize with it.
2. During operation, the Timy3 should not be switched off and on. This would require a resyn-
chronization which could lead to the loss of timing impulses during the first 5 minutes.
In this menu item, the WTN specific settings can be executed (further explanations see also
A Timy2 with an external WTN can be operated in nearly an identical way as a Timy3. Howev-
er, there are two essential differences:
•
The Timy3 can switch off the WTN module in order to save energy.
•
The channels of the Timy2 with external WTN module are physically triggered. This me-
ans that triggering the channels also exists on the banana sockets. This is not the case for
the Timy3.
9.9.1
WTN POWER
This is for switching on and off the internal WTN module. For energy saving reasons, the
module is deactivated by default. For using the functions of the WTN, it must be turned on.
•
<OFF> Standard
•
<ON>
9.9.2
STATE
1 ...... switch to screen 2 by pressing key
and
at the same time
2 ...... number of direct neighbors (also other teams on the same frequency)
3 ...... number of devices in same team
4 ...... teams on same frequency
5 ...... transmission power: (10 – 100 mW)
6 ...... link quality indicator
7 ...... receive signal strength indicator
8 ...... firmware version of WTN
9 ...... adjusted team
10 .... adjusted channel
11 .... adjusted edge mode
12 .... adjusted Baud rate for display board
13 .... adjusted Baud rate for RS232
14 .... transmission status
Summary of Contents for Timy3 WP
