ALGE-Timing Timy3 WP, Manual General, Page: 29 / 40

Manual
Timy3 - General
-29-
Link Quality Indicator (Lqi):
* ........... poor link quality
** .......... medium link quality
*** ........ good link quality
Receive Signal Strength Indicator (Rssi):
-127 ..... no connection
-65 ....... worst receive signal strength quality
+20 ...... best receive signal strength quality
Transmission Status:
0 to 4 ........ impulse on channel
C ............... delayed channel times by RS485
G............... data for display board
S ............... serial data
V ............... version conflict within the network
P ............... pulse hold message
M .............. update or settings package
R ............... RS485 command
9.9.3 SETTINGS
•
<RADIO POWER> 10 (standard), 25, 50 100 mW
•
<RS232> OFF, ON (standard)
•
<EDGE>
↑
only rising,
↑+↓
rising and falling
•
<RF-UPDATE> ON, OFF (start with F0 and cancel with F1); at least one
participant must be connected
•
<ADVANCED SETT.> menu is blocked (only for ALGE factory settings)
9.9.4 TEAM
Settings of the team (1-9 A-F) – see also Manual for WTN
9.9.5 SOCKET
It is possible to configure nine timing channels in this mode for the WTN. Impulses taken in the
socket mode are marked with ‘t’ in the front (e.g.
t0124 ST 10:12:34.0384
)
•
Start the external WTN impulse devices and adjust them
to the same team as the Timy3 (e.g. photocell PR1aW,
push button WTN-PB).
•
Make sure that the WTN is activated in the Timy3.
•
Press the menu button .
•
Select <WTN> and press .
•
Select <SOCKET> and press .
•
Under “Neighbors” it must now show the number of im-
pulse devices that you have activated.
•
Select with the F-keys the device that you want to read
(e.g. F3 = all WTN-devices).
•
Initiate an impulse on the start impulse device (C0).
•
1 SOCKETS is displayed.
•
Initiate an impulse on the next impulse device (C1).
•
“2 SOCKETS” is displayed.
•
etc.
•
When you are finished press the menu button .
•
Start your timing.