Photofinish OPTIc2.NET
Page 42
Cycle Time
For the result list for street cycling needs a special way to show
the time. It shows riders that arrive in a group with a group time,
but the ranking is by arrival order. The OPTIc2NET software
allows doing this automatically.
When you do the evaluation for each rider it will write the run
times in the column “Run Times”. If you activate as well the col-
umn <Time (Cycle)> it will show you a column with the times
that are important for cycling (including group times). The gap
for the group time you can input by clicking on the menu <Set-
up>, than <Heat list setting> and then input the gap for the <Cy-
cle Time>. With this gap you set the time difference for the
group. A rider that has more delay to the previous finisher than the
gap in this field will have a new time, if he is within this gap time he
will be listed in the same group of riders.
It is possible to switch each cycle time between the gap and the
symbol for same time by clicking on the arrow behind each time in
the column.
The factory setup for the Cycle Time (gap) is 1 second.
8.3.4 Menu <Connection>
IDCam
See point 15 “Integration of IDCam”.
ALGE display
To activate different modes of the
ALGE-TIMING
display board (D-LINE or GAZ).
Run time
The running time of the active race is shown on the display board. Further adjustments
are possible in the Time Window.
Day Time
The display board shows the time of day (hours and seconds).
Hold time
You can adjust in seconds how long the stop time is shown on the display board after a
finish impulse (if you select the automatic mode in the Time Window).
Shift day time
To adjust the time of day format on the display board. This function must be activated
to show the time of day correct on a 6-digit display board.