6
LOCATING AND ASSEMBLING THE PIZZA OVEN:
When determining a suitable location for your
Alfresco
™ Pizza Oven, take into account concerns
such as exposure to wind, rain, sprinklers, proximity to traffic paths and keeping any gas supply line runs
as short as possible.
Locate the oven only in a well
-
ventilated area. Never locate the oven in a building, garage, breezeway,
shed or other such enclosed areas without an approved ventilation system. Never locate the oven over,
under or next to unprotected combustible construction. During heavy use or when using wood for
flavoring dishes, the oven will produce a lot of smoke.
CLEARANCES:
TO NON
-
COMBUSTIBLE CONSTRUCTIONS:
A minimum of
3”
clearance from the back of the oven
Top Rear Exhaust
to non
-
combustible
construction is required to allow the hot exhaust air to escape freely. (Not applicable to built
-
in models)
A minimum of
1”
clearance around the oven perimeter (bottom section) to non
-
combustible construction
is required to allow air intake through the bottom of the unit for proper flame combustion.
TO COMBUSTIBLE CONSTRUCTIONS:
A minimum of
12”
clearance from the back of the oven
Top Rear Exhaust
to combustible construction
is required to allow the hot exhaust air to escape freely. This requirement however is not applicable to
built
-
in models. Built
-
in models
must
be built and installed in non
-
combustible construction without
exceptions.
A minimum of
1”
clearance around the oven perimeter (bottom section) to combustible construction is
required to allow air intake through the bottom of the unit for proper combustion. Combustible materials
however,
should never
touch any exterior surface of the oven.
The
Alfresco
™ Pizza Oven
should never
be operated while on top of combustible countertops such
as, Formica®, Corian®, Azure®, Quartz Composite materials including wood, laminates, wood
composites nor countertops with combustible materials, binders or components including finishes such
as oils, lacquer, varnish, shellac, paints or other combustible finishes.
ASSEMBLY:
FREE STANDING MODELS:
Before using your
Alfresco
™ Pizza Oven, complete the following steps:
1.
Remove all packaging materials.
2.
Ensure that the IR burner is positioned correctly on it’s orifice, and is fully seated onto its
supports.
3.
Install the Hearth Stones, Top radiant stone and back Fire Log with it’s support stand.
4.
Make the connection to the gas regulator according to the instructions on pages 10 & 11
for your gas type.
5.
Allow a 6” clearance around all sides of oven for proper air movement.
BUILT
-
IN MODELS:
Before locating your
Alfresco
™ Pizza Oven into your Non
-
combustible enclosure, complete the
following steps:
Summary of Contents for AXE-PZA
