Alfresco AXE-PZA, Care And Use Manual

Page: 29 / 36

29
INSTALLING A NEW LIGHT BULB:
NOTE: When replacing light bulbs, use a soft clean cloth (cotton or paper towels) when handling lights.
Always keep halogen lights free of fingerprints and grease when replacing. Because of the light bulb’s
very high operating temperature, grease or fingerprints left on the light bulb might reduce the bulb’s life.
Insert a new light bulb using a clean cloth and do not force the light bulb in the socket. Very little effort
is required for the bulb to “SNAP” and lock into place. Look at the bulb and verify that no fingerprints
are left on it. Wipe off any fingerprints and or grease that might have accidentally come in contact with
the glass of the light bulb.
Replace the light cover by inserting it into the light fixture at a slight angle until it “SNAPS” into place.
Power up your
Alfresco
™ Pizza Oven and verify the light bulb operation by turning on the light
switch.
FRONT PANEL ACCENT LIGHTS:
The Front Panel accent light are located under the front panel bullnose. In order to replace them, the
Front Panel must be removed by the following procedure:

Remove the Front Panel Gas Knobs.

Remove the Front Panel bottom Hexagonal Bolts (2)

Remove the Front Panel Top screws (2)

Remove the panel by unplugging the light switch and
the accent light harnesses.

Remove the accent light panel by removing the 2
10
-
32 screws holding it to the main Front Panel.

Remove the accent light electrical plug by pulling it straight out.

Replace the accent light by removing the nut and lock washer.

Re
-
install all components in reverse order to finish the lamp replacement.
BOLT
SCREW
SCREW
BOLT
LIGHT SWITCH
ACCENT LIGHT ASSEMBLY
(LIGHTS AND HARNESS)
SCREW
SCREW
FRONT PANEL
ASSEMBLY
ACCENT
LIGHT
REMOVE PLUG
ACCENT LIGHT PANEL ASSEMBLY